Arabidopsis eFP Browser
Data Source
Mode
Primary AGI ID
Secondary AGI ID
Signal Threshold
Chemical
Hormone
Developmental Map At-TAX
Developmental Map
Tissue Specific
Natural Variation
Seed
Abiotic Stress At-TAX
Biotic Stress
Abiotic Stress
Development RMA
Light Series
Root
Absolute
Relative
Compare
Links to Poplar Orthologs in Poplar eFP Browser
View
expression pattern
for gene At1g68530's Poplar ortholog (PtpAffx.224432.1.S1_at)
View
expression pattern
for gene At1g68530's Poplar ortholog (Ptp.2963.1.A1_at)
View
expression pattern
for gene At1g68530's Poplar ortholog (PtpAffx.342.1.S1_s_at)
View
expression pattern
for gene At1g68530's Poplar ortholog (PtpAffx.206214.1.S1_at)
View
expression pattern
for gene At1g68530's Poplar ortholog (PtpAffx.109739.1.S1_s_at)
View
expression pattern
for gene At1g68530's Poplar ortholog (Ptp.6592.1.A1_s_at)
View
expression pattern
for gene At1g68530's Poplar ortholog (PtpAffx.101967.1.A1_at)
View
expression pattern
for gene At1g68530's Poplar ortholog (Ptp.3386.1.S1_s_at)
View
expression pattern
for gene At1g68530's Poplar ortholog (PtpAffx.224411.1.S1_at)
View
expression pattern
for gene At1g68530's Poplar ortholog (PtpAffx.55455.1.S1_a_at)
View
expression pattern
for gene At1g68530's Poplar ortholog (PtpAffx.150150.1.S1_s_at)
View
alignment
for any Poplar orthologs for At1g68530
This probe set reaches its maximum expression level (expression potential) of
5225.38
in the
Developmental Map or Tissue Specific
data source.
Some samples exhibit high standard deviations for replicates. You can use
standard deviation filtering
to mask those with a deviation greater than half their expression value.
260267_at was used as the probe set identifier for your primary gene, At1g68530 (CER6_CUT1_G2_POP1__KCS6 (3-KETOACYL-COA SYNTHASE 6); catalytic/ transferase, transferring acyl groups other than amino-acyl groups )
See information about this gene at
TAIR
Find co-expressed genes with
Expression Angler
Perform electronic Northerns to examine this gene's response under different conditions with
Expression Browser
See
distribution of average expression levels
for the probe sets on the ATH1 GeneChip in the
samples used for the eFP Browser
, to determine if a given gene is a high or low expresser. The small graph that is shown on the eFP output in Compare and Absolute modes indicates the highest level of expression for the primary gene in red, and the highest level of expression of the secondary gene in blue. The grey line indicates the maximum level of expression of the first gene in any data source